Versions Compared

Version Old Version 16 New Version 17
Changes made by

정은진

정은진

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

  1. Enter cluster name as your definition and click on "Server Connection" to bring informations of host identities.
    Next step is unable to proceed if the network is not connected. If there was an existing heartbeat configuration, its information will be remained.

    [Figure] Initial Heartbeat Settings

     

  2. Enter hostname or IP address of the node.
    MCCS will brings and shows hostname and network informations for the node.

    [Figure] Server Connection

  3. Edit node name as your definition and select IP address for heartbeat and mirror network.


    [Figure] Select IP address

     

    Info

    Default node name is host name of the node. Node name for clustering doest not must be identical to it's host name.
    MCCS needs at least 2 heartbeat configuration, 3 heartbeat is recommended. 

  4. Click 'Test' to verify connectivities between two nodes.

    [Figure] Verifying connectivities between nodes

     

    Warning

    미러 라인은 복제 프로그램에서 사용될 데이터 복제 네트워크 입니다.

    미러 디스크 리소스를 사용하려면 반드시 3개의 핫빗으로 MCCS 를 구성해야 합니다.

    또한 미러 디스크 리소스를 포함한 MCCS 를 3개의 핫빗에서 2개의 핫빗으로 변경할 경우 정상적인 동작을 보장할 수 없습니다.

     

    Mirror line is data replication network for replication program. Each pair of IP address between nodes must be on the same subnet.
    If these subnet are not matched between nodes, 'Test' button for verification will not be enabled.
    When you use mirror disk resource, you can configure three heartbeats.
    It is highly recommended to configure the heartbeats at least three when you use mirror disk resource.


  5. Click 'Yes' button, when you confirm for heartbeat configuration.
     
    [Figure] Applying Heartbeat configuration

  6. Click 'OK' button to complete.
     
    [Figure] Heartbeat configuration is completed 

웹 콘솔 접속

...



Web Console Connection

When you first connect the MCCS console after configure heartbeat, you may need to update or enter an valid license key if you doesn't enter this during installation.

  1. MCCS 웹서버에 접속합니다. 비밀번호를 입력합니다. 접속을 클릭하여 콘솔에 접속합니다. 

    [그림] MCCS 웹콘솔 접속화면 및 로그인 화면

  2. Select Windows(W)->Preferences.

    [그림Figure] MCCS 웹콘솔 접속 후 화면main web console  

  3. Click 'License Update' button for each node in the 'License Information'.

    [Figure] Preferences View

  4. Enter a valid license key (temp. or perm.) for both nodes.

    [Figure] Entering an valid license key

...