Versions Compared

Version Old Version 27 New Version Current
Changes made by

헌규임

정은진

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

  1. Enter cluster name as your definition and click on "Server Connection" to bring informations of host identities.
    Next step is unable to proceed if the network is not connected. If there was an existing heartbeat configuration, its information will be remained.

    Image RemovedImage Added

    [Figure] Initial Heartbeat Settings

     

  2. Enter hostname or IP address of the node.
    MCCS will brings and shows hostname and network informations for the node.

    [Figure] Server Connection

  3. Edit node name as your definition and select IP address for heartbeat and mirror network.

    Info

    Default node name is host name of the node. Node name for clustering doest not must be identical to it's host name.
    MCCS needs at least 2 heartbeat configuration, 3 heartbeat is recommended. 

     

     

  4. Click 'Test' to verify connectivities between two nodes.
    Image RemovedImage Added
    [Figure] Verifying connectivities between nodes

     

    Warning

    Mirror line is data replication network for replication program. Each pair of IP address between nodes must be on the same subnet.
    If these subnet are not matched between nodes, 'Test' button for verification will not be enabled.
    When you use mirror disk resource, you can configure three heartbeats.
    It is highly recommended to configure the heartbeats at least three when you use mirror disk resource.


  5. Click 'Yes' button, when you confirm for heartbeat configuration.
     
    [Figure] Applying Heartbeat configuration

  6. Click 'OK' button to complete.
     
    [Figure] Heartbeat configuration is completed 


...