Content Comparison

...

1. Select the group -> Right click with the mouse -> Add the resource.   
   
2. In resource wizard, select a shared disk DR and click the Next button. 
   

3. The shared volume set of resource wizard will display the drive characters that can be used to compose the shared disk DR and the existing drive characters that are already configured.
   You cannot inquire about information at the remote server. So, you need to enter IP addresses on your own. 
   

   Warning
   The drive characters to be used as the shared disk DR should be same on the both servers that compose a cluster. Data will be copied to the target node from the source node. The remote server cannot be the source. Be careful when you select the drive character where data exists. If you try to add the existing mirror volume, <mirrored> will be added to the volume letter.

   
   

   
     [Figure] Shared Disk DR Resource Added

   
   

4. Click the 'Additional Setup' to define the synch mode and the disk test option.
   

   Info
   <Sync mode> Once selected, the sync mode cannot be reversed. So, be careful. Sync mode : Response is slow but there is no data loss involved. Async mode : Relatively faster than the sync mode but it can suffer from data loss. <Disk test option> Set the disk test command option. For more details on the function, refer to MSDN.

    
    [Figure] Shared Disk DR Additional Setting

   
   

5. Press the Finish button after adding the shared disk DR resource, the following warning screen will be displayed.
   Check again if it is the correct source server selected.
   If not, then click on the 'Cancel' button and set it again. 

   
   [Figure] The warning screen displayed when you press the Finish button after adding the shared disk DR resource   
    

6. Click the 'Finish' button to add the shared disk DR resource. You can immediately check the result in the management web console.

...