Content Comparison

...

1. To add a group, select 'group name → right click → Add Group' from configuration tree.
   Or select 'Edit(E) → Add Group' from main menu.
   
   [Figure] Adding a Group 
   
   

2. If you select to register a group, you will see the initial group registration screen.
   In the initial group registration screen, enter a group name and move the operation target node from the left window to the right window.

    

   Info
   If you select only one operation target node, then you can create a single node group. If you select this option, a group is not able to perform failover in case of trouble. (If you have selected a single node cluster in the installation program, only one node will be displayed as an available node.)

   
   [Figure] Operation Target Node Selection
   

    

   Info
   Unlike failover group, Single node group does not support failover when failure occurs.

    

3. Press the 'Additional Setting' button to decide whether to set the group policy to failover or parallel operation.
   If you have added more than one node to the operation target node, additional setting will be activated.. 
   [Figure] Additional Settings View

   Info
   Failover group failover from active to standby node when failure occurs.  Parallel group is configured with the resources that can be executed on more than 2 nodes at the same time. Parallel group does not support failover, but restart the service when it is failed in local node.

    

4. Designate a group policy and configure an application.
   For more on how to add each resource, refer to the below link.
   Refer to the descriptions of adding complex applications in "7.4 Complex Application Resource."
   Refer to the description of adding basic application in "7.3 Basic Application Resource."
   Refer to the descriptions of adding service resource in "7.7 Service Resource."
   

   Info
   If there is something wrong with the resource added, you can press the X mark to delete it. You can change the starting/terminating order of added resources by pressing the arrow icon.

    
   [Figure] Application Configuration
   
   

5. Configure the network related resource.
   
   For more on how to add each resource, refer to the below link.
   Refer to the descriptions of adding network card in “7.1 Network Card Resource."
   Refer to the descriptions of adding a network address in "7.2 Network Address Resource."

   
   

    

   Warning
   Before you can use the IP resource, you must define the network adaptor resource.

    
   [Figure] Network Configuration

   
   

6. Configure the disk related resource.
   For more on how to add each resource, refer to the below link.
   Refer to the descriptions of adding shared disk resources in "7.5 Shared Disk Resource." 
   Refer to the descriptions of adding SCSI reservation resource in "7.9 SCSI Reservation Resource."
   Refer to the descriptions of adding mirror disks in "       7.6 Mirror Disk Resource  ."
    
   [Figure] Disk Configuration  
    
7. Once you have configured all the resources, it will suggest a dependency recommended by MCCS.
   If you want to change the dependency, select the Dependency tool in the right tab and change it.
    
   [Figure] Recommended Dependency Modified
   
   
   
8. After creating dependency, detailed information of group configuration can be shown as below.
   
    [Figure] Group Detailed Information View 
   
   

...