| Section | |||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
|
...
It shows license of the product.
You must agree the license to proceed installation.
[그림Figure] MCCS 라이선스 동의 화면Agreeing to the MCCS License
Directory Selection
Select a directory to install MCCS.
Click [Browse] to select other installation directory.
...
JRE Directory Selection for MCCS (Setting view appears only when PowerLinux is installed.)
Select the folder where JRE is installed. Click Browse to select other JRE folder.
...
| Info |
|---|
A single node cluster is a cluster made of a single node. |
SingleNodeCluster Setup does not require any other settings to run MCCS in a node.
...
[Figure] MCCS SingleNodeCluster Setting view
웹 콘솔 접속 포트 설정
...
...
Web console access port setting
Set the web console access port (UIPort)를 설정합니다. 설정된 웹 콘솔은 웹 브라우저로 MCCS 웹 콘솔에 접속하기 위해 사용됩니다.
기본 포트는 10080 이 됩니다The configured web console is used to access the MCCS web console by using a web browser.
Default port is 10080.
[그림Figure] MCCS UIPort 설정 화면Setting
Start Installation
[Figure] Start MCCS Installation view
...
[Figure] After inserting license view
라이선스를 입력하지 않으면 아무런 정보도 출력되지 않습니다If you don't enter the license information, nothing will be displayed.
[Figure] License not inserted View
...
Close the web console.
Using the following command, terminate the MCCS service for the both nodes.
Info 서비스 중지 및 시작은 반드시 root 사용자로 실행해야 합니다When you start or stop the service, you must use the root user role.
Code Block title Stop MCCS Service service mccs_agent stop
- At the both nodes, open the MccsServer.ini (file location: $MCCS_HOME\bin\) file and switch to the new language as follows and save it.
If you change the language in the mccsserver.ini file, the log output will be generated in that language.
If you want to change the language for the web console, refer to "MCCS User Manual: Appendix E. Environment Setting".- Korean → ko
- English → en
- Chinese → zh_CN
[그림Figure] Language Change in the mccsserver.ini 파일의 언어 변경 화면file
Using the following command, start the MCCS service for the both nodes.
Code Block title Start MCCS Service service mccs_agent start
- After accessing the MCCS web console, check the changes made.