4- MCCS Installation
Installation
Install by Web Console
To install MCCS, Please insert MCCS CD Media disk into the CD-ROM.a
Open CD-ROM drive and execute installer.
MCCS Installation file is different by OS version.
Warning
You must have root privileges to install the MCCS.
The installation will be terminated due to lack of required permissions with non-root user.
Both of 32 bit, 64 bit file is executed by as root user.
MCCS_linux_4.sh
Language Selection
When execute installer a dialog box of 'Choose Setup Language' appears as below.
elected language will be used as the primary language of MCCS.
[Figure] Language Selection Screen
Start Installation
This is the initial setup window of MCCS installation wizard.
Click [Next] to proceed to the next step.
[Figure] MCCS Installation View
License Agreement View
It shows license of the product.
You must agree the license to proceed installation.
[Figure] Agreeing to the MCCS License
Directory Selection
Select a directory to install MCCS.
Click [Browse] to select other installation directory.
[Figure] MCCS Directory Selection
If MCCS was installed and/or deleted before in the past, a warning message will be prompt as shown below asking if you would like to install MCCS in the same directory.
It is recommended to install in the same directory.
[Figure] MCCS Existing Directory Selection Screen
JRE Directory Selection for MCCS (Setting view appears only when PowerLinux is installed.)
Select the folder where JRE is installed. Click Browse to select other JRE folder.
[Figure] Select MCCS JRE View
Firewall Setting
Firewall setting is done automatically.
SingleNodeCluster Setup
SingleNodeCluster can be selected here.
A single node cluster is a cluster made of a single node.
Do not check the setting page when you configure MCCS by using a two node cluster.
SingleNodeCluster Setup does not require any other settings to run MCCS in a node.
[Figure] MCCS SingleNodeCluster Setting view
Web console access port setting
Set the web console access port (UIPort). The configured web console is used to access the MCCS web console by using a web browser.
Default port is 10080.
[Figure] MCCS UIPort Setting
Start Installation
[Figure] Start MCCS Installation view
Finish Installation and Enter License key
You will see a view to insert license when installation is finished.
Enter the license key.