Content Comparison

...

1. In the background, click on the MCCS link or open the web browser and access http://127.0.0.1:<UIPort>/main.

    
   [Figure] MCCS Shortcut Link

   
   

2. When you access the link or URL, the following web screen will be displayed. The initial password is set to 'password'. 

   

   [Figure] MCCS Web Console Access View

    

   Info

   Info You can change this Port number in the Heartbeat Setting menu and please, refer to 'Appendix F. Modify HeartBeat Configuration' of MCCS user guide about this. - ID : Account name to connect MCCS console. Default account is 'admin'. - Password : Default value is 'password'.. Info administrator : This account can all of control of the MCCS for group and resource like add, delete, switch, edit, setting dependency and etc. monitor : This account can only view the state of group and resources. Info You can change this in the Cluster Attributes View from Cluster Attributes tab and please, refer to 'Chapter 2. Management Web Console' of MCCS user guide about this.

    

    

3. Press the [Login] button to start the initial heartbeat setting. 

...

1. Enter cluster name as your definition and click on "Server Connection" to bring information of host identities. 
   Next step is unable to proceed if the network is not connected. 
   If there was an existing heartbeat configuration, its information will be remained.
   
   [Figure] Initial Heartbeat Settings
   
   
2. Enter hostname or IP address of the node. Or enter 127.0.0.1 when you connect to local node.
   MCCS will brings and shows hostname and network informations for the node.
    
   [Figure] Server Connection
   
   

3. Edit node name as your definition and select IP address for heartbeat and mirror network.

   Image Added
   

   [Figure] Select IP address

    

   Info
   Default node name is host name of the node. Node name for clustering doest not must be identical to it's host name. MCCS needs at least 2 heartbeat configuration, 3 heartbeat is recommended.

   
   

4. Click 'Test' to verify connectivities between two nodes.
   
   [Figure] Verifying connectivities between nodes

    

   Warning

   Mirror line is data replication network for replication program. Each pair of IP address between nodes must be on the same subnet. If these subnet are not matched between nodes, 'Test' button for verification will not be enabled. When you use mirror disk resource, you can configure three heartbeats. It is highly recommended to configure the heartbeats at least three when you use mirror disk resource.

   
   
   

5. Click 'Yes' button, when you confirm for heartbeat configuration.
   
   [Figure] Applying Heartbeat configuration
   
   
6. Click 'OK' button to complete
   
   [Figure] Heartbeat configuration is completed  
   

...